Is there anything else to note about fuse holders?Let’s follow the fuse holder manufacturer to learn more:

When electroplating fuse terminal, there are certain requirements on the surface of electroplating production area: anti-corrosion, anti-seepage and anti-liquid;There is a tank on the production line to collect spray and cleaning fluid.The first requirement of electroplating production line with good electroplating quality is high quality automatic continuous electroplating production line equipment, which requires good electroplating production process habits.The following are the matters needing attention in the process of fuse base terminal electroplating:

1. Adjust the structure of automatic continuous electroplating production line.Each part and its tightness, lubricity, and clearances, such as blade clearances, must be adjusted before use.At the same time, if parts are to be replaced, procedures must be followed.The parts will not be damaged during replacement.

2, to pay close attention to the use of automatic electroplating production line equipment.During the operation, you should not leave the post without permission.You should always be on your toes, especially for unusual situations.Once the abnormal situation occurs during the operation of the equipment, the power supply of the equipment should be cut off immediately.

3. When the automatic continuous electroplating production line equipment is working, it cannot be interrupted due to adjustment.This means that during the working week of the equipment, it is best not to make any adjustment or maintenance during this period, otherwise the continuous operation of the fully automatic plating production line will be stopped, which will lead to discontinuity of the plating process and continuity and process deviation (such as coating thickness) between the work results.

In a nutshell, fuse holder terminal plating quality is good or not is directly related to PCB welding work of the follow-up, plating quality directly affect the welding quality, we often meet with bad welding production technology, electroplating oxide etc on the problem, metal plating surface is very unstable, this is also our has been emphasized the importance of fuse holder terminal plating process.

Above is the note about fuse block introduction, we are an fuse block factory, have 20 years of production and development experience, if you need to buy or customize, welcome to contact us ~